Specifications
Working temperature: -10 °C +40°C
Working Humidity: 5…95% RH non-condensing
Voltage: 100…240 Vac, 50/60 Hz
Max Load: 10A, 2200W
MCU: EFR32MG21
- The SonOff MINI DY user manual is here.
- The SonOff MINI DY general DOC is here.
- The SonOff user manual is here.
ZigBee MINI DY Wirings
Green LED status
Pair the SONOFF ZigBee in Home Assistant using the deCONZ gateway
To pair this relay with deCONZ you must:
*** Connect the 220vac (Nin-Lin)
*** Press the reset button
*** Launch deCONZ Phoscon search as Lights
See the SetUp below.
- First reset your SONOFF ZigBee by pressing for 10 seconds the reset button until the green led flash
- Next select: deCONZ and Phoscom (see the image below)
- Now click on the three horizontal bars at the top left, see the red box in the image below.
- From the page that appears choose LUCI (Lights)
- Now select: ADD NEW LIGHTS
- After somesecons will appears a new light that is your SONOFF ZigBee, in our case is named:
On/Off light 2 – SONOFF – 01MINIZB
in our case is this:
NOTE:
The last SONOFF ZigBee smart switch return the switch status connected to the pins named S1 and S2.
The old SONOFF ZigBee smart switch (old firmware inside) don’t return the switch status connected to the pins named S1 and S2.
IMPORTANT:
If to S1 and S2 you have connected a switch, every time you change the switch position, will change the state of the lights.
In other words, assuming that:
*** relay is on
*** switch open (S1 – S2)
if you close the switch the light goes out and vice versa.
Remotely it is always possible to change the state of the light regardless of the state of the switch.